ES UN PRODUCTO DE       RESIN- FAST / Instructions       Prior to mixing, each component must be stirred so that a homogeneous mixture is obtained. Mix the sediment completely. Mix Resin-Fast approximately 30 seconds until a uniform color is obtained. Two tins of Resin-Fast are sufficient to produce 2-3 complete dental arches. The material can be removed after 30 minutes. Final hardness is achieved after 90 minutes. Then the model can be trimmed.             Due to its high edge stability, Resin-Fast is perfectly suitable for precision-fit bridge and crown work.       If smaller quantities are used, fill component A and B into separate syringes. Pour equal quantities of Resin-Fast into a silicone beaker (approximately 2 ml for one die) and mix to obtain a homogeneous material. Please note, material in syringes must be used within 5 days. Pour Resin-Fast into the impression. The excellent flow properties prevent the formation of bubbles even in impressions with thin edges. The hardened resin can be drilled and trimmed. The stability avoids dimensional changes and guarantees precise models.   Copyright 2002 - Flexafil S.A.C.I. - Todos los derechos reservados Leopoldo Marechal 1312 - (1414) Buenos Aires - Argentina Telefax: (54-11) 4854-4814 - info@sabilex.com